TMC2209 does not communicate with SKR1.4

Configuration, and jumper setting (a single jumper per stepper) is verified against [www.youtube.com] (part 1 and two)
The sensorless homing pins clipped on Bigtreetech TMC2209-1.2
The printer "works" - except for not utilizing TMC2209 , not being able to set current, or communicate with them.

#define ?_DRIVER_TYPE TCM2209
#define TMC_DEBUG

and other settings applied (config attached) Marlin 2.0.x-bugfix branch.

Still. the M122 , M906 and other TMC related commands are "unknown" - nor is there anything stepper-related on the display.

Confirmed your a dyslexic

?_DRIVER_TYPE TCM2209
               ^^

These characters are swapped in your Configuration.h

Should be TMC2209
Ie Tango,Mike,Charlie,Two,Two,Zero,Nine

Edited 1 time(s). Last edit at 08/21/2020 05:15AM by Dust.

Thank you for embarrassing me as deserved