Welcome! Log In Create A New Profile

Is it possible to enable notification after each movement of steppers?

enwickler

Is it possible to enable notification after each movement of steppers?
April 25, 2021 04:03PM

Registered: 2 years ago
Posts: 8

Normally Marlin responses to each command with "ok" as acknowledgement. I'm wundering whether it is possible to provide any notification/message after finishing every G0 command, namely every movement of steppers? It there already any paraemeter in Configuration.h for that purpose?

Reply Quote

Dust

Re: Is it possible to enable notification after each movement of steppers?
April 26, 2021 12:16AM

Admin
Registered: 12 years ago
Posts: 6,711

no longer accurate.. ignore.

Edited 1 time(s). Last edit at 04/27/2021 04:07AM by Dust.

Reply Quote

dc42

Re: Is it possible to enable notification after each movement of steppers?
April 26, 2021 01:27AM

Registered: 9 years ago
Posts: 14,635

The Marlin build for nanoDLP does that, it returns "z move compl" after each move. I'm not sure whether this is an option in the standard Marlin source code or only in a fork.

Edited 1 time(s). Last edit at 04/26/2021 01:28AM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

enwickler

Re: Is it possible to enable notification after each movement of steppers?
April 26, 2021 02:41AM

Registered: 2 years ago
Posts: 8

thanks for your reply! What do you mean with

Quote
Dust
10's

and

Quote
Dust
long lines

Reply Quote

enwickler

Re: Is it possible to enable notification after each movement of steppers?
April 26, 2021 02:42AM

Registered: 2 years ago
Posts: 8

Thank you for the insight! Is nanoDLP kinda opensource repo?

Reply Quote

dc42

Re: Is it possible to enable notification after each movement of steppers?
April 27, 2021 03:43AM

Registered: 9 years ago
Posts: 14,635

I'm not an authority on Marlin because I don't use it; however, from the source code file [github.com] it looks to me that if you enable NANODLP_Z_SYNC and NANODLP_ALL_AXIS in config.h then the standard Marlin source code provides this feature.

Edited 1 time(s). Last edit at 04/27/2021 03:43AM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].