Hello,
I have an SKR1.3 + TMC5160 for a delta kossel.
marlin is 2.0.9.1
in the menu I do not have in menu function to move x y z axes. this option are missing.
when I try to make an home function few sec after printer goes on halt and I need to reset it.
I would like to use pronterface with usb cable to use move function but proterface does not find any printer even if windows can see the memory card on skr board.
Can someone assist with this issue ?
What do I need to check in marlin to see if move function menu is activated ?
what can I do to not have printer in fault when I try to make an home function.