I designed a CoreXY machine and its pretty built and ready for firmware.

I did a basic configuration of the bugfix_2.0.x version of Marlin just to see if there were any errors before making all the very specific changes.

After flashing the machine with the new firmware, i noticed that i have no status screen and there's no pre-heat menu either. All i see is Ready in the top left of the screen and 6 incons for various stuff.

My old machine used a BTT SKR V1.3 and my new machines use the BTT Octopus V1.1. All of the machines use the BTT TFT v2.0.

The old machine used the same Marlin version and it has a status screen. I have no idea what's going on.

Thanks.

Nevermind. I figured it out. I was doing it completely wrong. I was tired and burned out.