Hi, I have an older Anycubic Delta running Marlin 1.1.9, all good -- until the Bed Leveling Probe stopped working. I put in a new one and this one has the opposite NC/NO settings.
Is it possible to reset and Save the Z_MIN_PROBE_ENDSTOP_INVERTING from "false" to "true" using an M-Code or G-Code and Save it back?
The Marlin installed is dated September 2019 and I cannot find the Config files anywhere and I have searched dozens of my backups, but found nothing that far back.
I do not want try an recreate the Config and Config_adv files as I just need to level the bed after a nozzle change as it was printing perfectly.
