@admin: If you want, you can delete it. Feel free.
Please forget my question, see here
Marlin issue 24372
Hello, my first post. I was just a reader until now.
I came into property of an Ender 3 clone (CTC A13). It's a piece of junk, but anyway. I'm an absolute rookie with Marlin and 3D printing. This question is addressed to SKR 2 owners with TMC drivers using UART.
I answered here
Marlin issue 24372.
I also asked here
SKR 2 issue 164, but didn't get an answer.
It might be a SKR issue!
Marlin-bugfix-2.1.x_220807_17_52
config_Marlin-bugfix-2.1.x_220807_17_52.zip
TMC2209s and Cartesian printer with 4 steppers
If somebody is willing to help me, please try:
Please use M122 and look at these values (just an example) sg_result 206 16 58 86. Now, please hold/brake your y-axis and move it. Does the y-value changes? You have to use M122 again to read it out. Thanks in advance.
It's working on x, z, and e as expected. I swapped my TMC2209s around, but no difference. Y stays at 16! Please tell me your results. SKR 2 has a lot of hardware bugs, maybe it's caused by the board.
Thank you.
Edited 1 time(s). Last edit at 08/15/2022 03:40PM by hcet14.
Attachments:
open |
download -
config_Marlin-bugfix-2.1.x_220807_17_52.zip
(89.4 KB)