Always 6 (micro)steps are used October 12, 2022 05:36AM |
Registered: 1 year ago Posts: 3 |
M114 D X:-7.0000 Y:-3.0000 Z:0.2000 E:0.0000 Count X:-35 Y:-15 Z:0 Logical: X:-7.000 Y:-3.000 Z: 0.200 Raw: X:-7.000 Y:-3.000 Z: 0.200 Leveled: X:-7.000 Y:-3.000 Z: 0.200 UnLevel: X:-7.000 Y:-3.000 Z: 0.200 Stepper: X:-35 Y:-15 Z:0 E:0 FromStp: X:-7.000 Y:-3.000 Z: 0.000 E: 0.000 Diff: X: 0.000 Y: 0.000 Z:-0.200 E: 0.000
#if AXIS_IS_TMC(X) #define X_CURRENT 800 // (mA) RMS current. Multiply by 1.414 for peak current. #define X_CURRENT_HOME X_CURRENT // (mA) RMS current for sensorless homing #define X_MICROSTEPS 16 // 0..256 #define X_RSENSE 0.11 #define X_CHAIN_POS -1 // -1..0: Not chained. 1: MCU MOSI connected. 2: Next in chain, ... //#define X_INTERPOLATE true // Enable to override 'INTERPOLATE' for the X axis //#define X_HOLD_MULTIPLIER 0.5 // Enable to override 'HOLD_MULTIPLIER' for the X axis #endif
Re: Always 6 (micro)steps are used October 12, 2022 08:20AM |
Admin Registered: 13 years ago Posts: 7,001 |
Re: Always 6 (micro)steps are used October 12, 2022 08:53AM |
Admin Registered: 13 years ago Posts: 7,001 |
Re: Always 6 (micro)steps are used October 12, 2022 09:38AM |
Admin Registered: 16 years ago Posts: 13,888 |
Re: Always 6 (micro)steps are used October 12, 2022 02:54PM |
Registered: 1 year ago Posts: 3 |
#define MIN_STEPS_PER_SEGMENT 6Great, thanks! I tried to search for "6" in code, but was flooded with result.
Quote
Dust
You cannot move to any micro step
G0 Z50 G0 Z0.2
Quote
Dust
anything more is more about noise reduction not resolution.
Re: Always 6 (micro)steps are used October 13, 2022 07:11AM |
Registered: 1 year ago Posts: 3 |