Full Graphic Smart Controller 12864 - No fan icon on display Marlin 2.1.2.2

Hello all

My first post here :-) so hello again.

I have a strange problem with Marlin 2.1.2.2 on the smoothieboard 1.0b.
The Full graphpic smart controller display does not show any fan icons.
Both fans (extruder/controller) are set as auto fans and work as they should.
The prints looks good too.
I have tried various things and also played a bit with the fan.h and dogm_statusscreen.h but without success.
Then I downloaded Marlin again and created the config again with the same result.
No fans.
Google brings no results so I think it is a rather rare phenomenon.
Next I will try the bugfix branch
Maybe someone have a idea what i could try also ?
Thanks in advance.
Cheers Joerg

Edited 1 time(s). Last edit at 04/23/2024 01:59PM by milz.

Tested 2.1.2.3 with the same result
Will put an issue on Github.

there is no such thing as 2.1.2.3, net yet anyways

You give almost no information. no config, not much to go on.

Auto fans are not visible. You cannot control them, so they are not on the display

Edited 2 time(s). Last edit at 04/25/2024 11:45PM by Dust.