mobo burned. Try to install new board. but earlier saved Marlin INO give me lots of errors now..

Hi all,

has been a long time since i've build my 3D printer, the famous 'Hypercube' by Tech2C.
Made some fairly good prints and was happy...

Than, after years of happy printing : Smoke!

Bought a new GT 2560 rev. A+ board..
Thought i could just upload the previous saved 'Marlin' INO...... but : Lots of errors.

See report: FoutrapportbijswapGT2560.docx

Any help available for an 'oldie' who forgot half (or more) of the tech he used to know :-) ?

Regards, Radio Ron.

Edited 1 time(s). Last edit at 10/20/2024 11:35AM by RadioRon.

... you can try to search an older Arduino-IDE, from this time/version too ... did this for some Python apps too, which only runs with the old Python 2.7 only, not with the actual IDE's

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

Well, the problem is that i just did that.

My backup pointed to an old Arduino IDE and when i tried to use this .INO file that's where the error's appeared.

I'm triïng to upgrade to a newer version of the Arduino IDE, A lot happened but now i'm stuck in a 'loop'

The 'new' .INO file keeps on loading..and loading... etc.