Bed leveling first probe is on X0 and not on X20
Posted by JustinTimeToo
|
Bed leveling first probe is on X0 and not on X20 July 06, 2025 01:52PM |
Registered: 10 years ago Posts: 29 |
I have a MKS Robin E3D v1.1 board. When I try to level the bed, using the inductive probe, it starts at X0, not at X20, which I thought I had set it too.
I'm using Marlin 2.1.2.5 specific for the above board.
My probe offset is -20,0,-1.2
What setting did I miss that the axis doesn't move to 20?
Configuration.h
I'm using Marlin 2.1.2.5 specific for the above board.
My probe offset is -20,0,-1.2
What setting did I miss that the axis doesn't move to 20?
Configuration.h
|
Re: Bed leveling first probe is on X0 and not on X20 July 15, 2025 09:50AM |
Registered: 10 years ago Posts: 29 |
|
Re: Bed leveling first probe is on X0 and not on X20 July 15, 2025 10:41PM |
Admin Registered: 14 years ago Posts: 7,283 |
Sadly most views are web scrapers for search engines and so called AI's
You didn't include your Configuration_adv.h which has
If you changed these it overrides "#define PROBING_MARGIN 20"
You didn't include your Configuration_adv.h which has
#if PROBE_SELECTED && !IS_KINEMATIC //#define PROBING_MARGIN_LEFT PROBING_MARGIN //#define PROBING_MARGIN_RIGHT PROBING_MARGIN //#define PROBING_MARGIN_FRONT PROBING_MARGIN //#define PROBING_MARGIN_BACK PROBING_MARGIN #endif
If you changed these it overrides "#define PROBING_MARGIN 20"
|
Re: Bed leveling first probe is on X0 and not on X20 July 18, 2025 01:34PM |
Registered: 10 years ago Posts: 29 |
No, I didn't include the adv.h. I will try to make a change in the spot you've mentioned. I'll try 30 or so.
The point is that if the probe would have gone to 20, as I hoped it would, it would have been fine. Why didn't it go to there is what I would like to know.
The point is that if the probe would have gone to 20, as I hoped it would, it would have been fine. Why didn't it go to there is what I would like to know.
|
Re: Bed leveling first probe is on X0 and not on X20 August 19, 2025 08:46PM |
Registered: 10 years ago Posts: 29 |
It's been two month since Dust suggested to use the "PROBING_MARGIN_LEFT". I had other project to do and got around to doing the change yesterday and unfortunately there was no difference. The X axis stays at 0 and didn't go to 22, as I had set in adv.h.
Somewhere there is a code that tell Marlin to ignore this command. I wish I knew where it is.
Somewhere there is a code that tell Marlin to ignore this command. I wish I knew where it is.
Sorry, only registered users may post in this forum.