I've just released this at [
github.com]. The changes since 1.15c are:
* Reduce incidence of false heating fault alarms, in particular "temperature rising much more slowly than the expected 0.0C"
* On the Duet WiFi, stepper drivers beyond the first 5 are now assumed not to be TMC2660 drivers, so the Enable signal is used as a driver enable instead of a chip select
The recommended version of DuetWebControl is still 1.12.
Edited 1 time(s). Last edit at 09/26/2016 04:15PM by dc42.
Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].