I was just reading the release notes for the 1.17 dev 4 and see there is change to the M305 defaults in the warnings. I just wanted to check that I understand this correctly.
I have a reprappro kit so I currently set this in my config.g -
M305 P1 R4700 ; Hot End
After upgrading to 1.17 I'll need to amend this to the following?
M305 P1 R4700 B4138 C0; Hot End
Just checking as I don't see the C parameter in the Gcode wiki?
DC42 Kossel 330mm x 2meters
My Thingiverse Creations