Heater not active while printing April 22, 2016 09:11AM |
Registered: 9 years ago Posts: 54 |
Re: Heater not active while printing April 22, 2016 10:59AM |
Registered: 8 years ago Posts: 475 |
M107; Shut down fan
T0; select tool
Re: Heater not active while printing April 22, 2016 11:03AM |
Registered: 10 years ago Posts: 665 |
Re: Heater not active while printing April 23, 2016 03:43AM |
Registered: 9 years ago Posts: 54 |
Re: Heater not active while printing April 23, 2016 03:45AM |
Registered: 9 years ago Posts: 54 |
Re: Heater not active while printing April 23, 2016 04:04AM |
Registered: 9 years ago Posts: 54 |
Re: Heater not active while printing April 23, 2016 12:20PM |
Registered: 8 years ago Posts: 475 |
Re: Heater not active while printing April 23, 2016 05:33PM |
Registered: 10 years ago Posts: 14,672 |
Quote
selva_tvi
And when I cancel the print, all the heaters are turned off. In the below link , [reprap.org], it shows that when a print is cancelled, 'stop.g' will be executed. But in the new firmware, 1.09x-DC42, I am unable to find the 'stop.g' macro. With previous 1.09 firmware, it was available.
The idea is, when the print goes wrong, I will cancel it. But, i dont want the heaters to shut down. It should remain active with the set temperature, so that I can go for new print. How this can be implemented with 'stop.g' and 'M0' gcode?
Thanks.
Re: Heater not active while printing April 26, 2016 12:27AM |
Registered: 9 years ago Posts: 54 |
Re: Heater not active while printing April 26, 2016 02:53AM |
Registered: 10 years ago Posts: 14,672 |