Extruder motor not running May 03, 2016 12:46PM |
Registered: 12 years ago Posts: 19 |
Re: Extruder motor not running May 03, 2016 02:27PM |
Registered: 9 years ago Posts: 1,159 |
Re: Extruder motor not running May 03, 2016 04:13PM |
Registered: 8 years ago Posts: 475 |
Re: Extruder motor not running May 03, 2016 04:30PM |
Registered: 8 years ago Posts: 475 |
Re: Extruder motor not running May 04, 2016 05:07AM |
Registered: 12 years ago Posts: 19 |
Re: Extruder motor not running May 04, 2016 08:28AM |
Registered: 10 years ago Posts: 14,672 |
Quote
PRZ
Looking the M563 command, the example refer to drive 0:5 and 6, but I don't understand, as if the drive references are taken after the X,Y and Z, there is no drive 6, as there is a maximum of 6 extruder drives (2 on the Duet 0.8.5 and 4 on the Duex 4) so last drive shall be D5 ?
In the code extract listed in the referenced thread, there is indeed a total of 9 drives.
Re: Extruder motor not running May 04, 2016 08:45AM |
Registered: 12 years ago Posts: 19 |
Re: Extruder motor not running May 05, 2016 03:38AM |
Registered: 12 years ago Posts: 19 |