guys i am dealing with strange behavior during printings. The one is the pause thing, another one is that while printign layer one the web interface was shown layer 3. Also the bed leveling says it supports only 3, 4, 5 points instead of zero.

this is the bed file

M561
G1 Z10 F200
G1 X30 Y7 F4000
G30 P0 Z-100000
G1 Z10 F200
G1 X30 Y188 F4000
G30 P1 Z-100000
G1 Z10 F200
G1 X200 Y186 F4000
G30 P2 Z-100000
G1 Z10 F200
G1 X200 Y7 F4000
G30 P3 S Z-100000
G1 Z10 F200
G1 X100 Y98 F4000
G30 P4 S Z-100000
G4 P1500 ; Leave the probe there to give the web interface time to report the plane points
G1 Z10 F200

any ideas ?

---

Delta Printer
Duet 0.8.5 firmware 1.19

sorry guys i fixed the bed problem as it is clear what was wrong. i ll come back if something will happen again . sorry for the post

---

Delta Printer
Duet 0.8.5 firmware 1.19