Hi,
I am using IR sensor along with DUET 0.6 (from Replikeo). I am happy with the IR Sensor.
I have an old Prusa i3 with Arduino+RAMPS. I would like to use the IR sensor (4-wire) from Replikeo to work with RAMPS (Marlin firmware).
I checked for connections, but I didnt find. DC42 has a solution, but it is for his 3 wire IR sensor.
How can I connect this 4 wire IR sensor with RAMPS? In RAMPS, it has to be connected to VCC, Gnd and Sig. But, in IR sensor, I am unable to find the pin connections. Please advice.
Also, any changes has to be made in Marlin?
Thanks
Selvakumaran
Edited 1 time(s). Last edit at 09/24/2016 06:01AM by selva_tvi.