Welcome! Log In Create A New Profile

just a quick connector question

Posted by chris33

chris33

just a quick connector question
May 07, 2017 09:19AM

Registered: 11 years ago
Posts: 973

Hi just enquiring as now im part of the duet 0.85 for my kossel build i need to finish will these connectors be ok Fleabay link
many thanks

Check my rubbish blog for my prusa i3

up and running
[3dimetech.blogspot.co.uk]

Reply Quote

dougal1957

Re: just a quick connector question
May 07, 2017 01:31PM

Registered: 10 years ago
Posts: 1,159

Yes they are the right things by the look of them but also have a look on Rapidelectronice for them they may be much cheaper there

Rapid Electronics Molex KK connectors

You may need a selection of 2 3 and 4 way shells and a few crimps plus a HT225 Crimp tool

HTH

doug

Reply Quote

dc42

Re: just a quick connector question
May 07, 2017 04:21PM

Registered: 10 years ago
Posts: 14,682

These [www.rapidonline.com] connectors also from Rapid are compatible and cost even less, but the MOQ is higher.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].