Cartesian resurrect-prologue.g file example

HI All

What would be a good resurrect-prologue.g file example?

I have an i3 cartesian style printer which I want this to run on.

I have already put the M911 in the config file, it already does save the resurrect.g, but I am missing the resurrect-prologue.g file, I found this out today after we had a power cut and I was 23 hours into a print.
I might just add I still have the print on the bed, hoping someone out there can help with the file so I don't have to restart the whole file.

I suggest you start by reading [duet3d.dozuki.com].

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Thank you DC42. I did read there but missed the last part. Thank you.

Quote
Dunston-UK
Thank you DC42. I did read there but missed the last part. Thank you.

That's because I only added the Cartesian example resurrect-prologue.g today, after relying to your post and looking at the page I was directing you to!

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

This file does not show up in the DWC editor. Do I just create one using notepad and then upload it or how?

You can create it in DWC. Go to System Editor and click on New File.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].