Quirks of rc5 December 07, 2018 01:30AM |
Registered: 8 years ago Posts: 338 |
Re: Quirks of rc5 December 08, 2018 10:30PM |
Registered: 8 years ago Posts: 338 |
Re: Quirks of rc5 December 09, 2018 02:58AM |
Registered: 8 years ago Posts: 5,232 |
Re: Quirks of rc5 December 09, 2018 04:40AM |
Registered: 8 years ago Posts: 338 |
That may be true. Didn't do much investigations. Busy to stop printing.Quote
Is the extruder running in scale_down mode, too?
Isn't the opposite true?Quote
Like the drivers suddenly run on halfsteps instead of 16x?
Re: Quirks of rc5 December 09, 2018 11:02AM |
Registered: 10 years ago Posts: 14,672 |
Quote
Brummie
Isn't the opposite true?
If the whole distance was calculated to 1000 steps and if using 16x microstepping would result in 10mm, than 2x microstepping should be about 80mm - right?
Re: Quirks of rc5 December 10, 2018 12:15AM |
Registered: 8 years ago Posts: 338 |