Welcome! Log In Create A New Profile


DuetWiFi Delta leveling problem

Posted by ventu22 
DuetWiFi Delta leveling problem
January 22, 2020 03:37PM
I have a problem with automatic calibration, the automatic procedure does not work, but the manual procedure starts.
I used the online configurator and inserted the switch that I connected to the E0 endstop terminal.
i have an anycubic predator,these are the configuration files
open | download - bed.g (1.3 KB)
open | download - config.g (4.6 KB)
Re: DuetWiFi Delta leveling problem
January 22, 2020 05:39PM
Please repost this on the forum at forum.duet3d.com because that's where our support staff hang out.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Sorry, only registered users may post in this forum.

Click here to login