Hello all.
I feel like an idiot for having this issue, but for some reason every time I load marlin firmware (both new and old releases) onto my Mendel I get gibberish when I connect with Pronterface. I've been working with sprinter loaded as my firmware and Pronterface seems to have no issue with it, however Sprinter under-preforms on the curves I'm trying to do (hence the attempt to change the firmware).
The board I'm using is an Arduino Mega 2560 with RAMPS 1.4
My OS is Windows 7 and the version of Arduino I'm using to load the firmware is v0023 (v1.0 only seems to choke and die so I went back to an earlier, stable version).
I'd appreciate any help you could give me in fixing this matter.
Thanks.
Edited 1 time(s). Last edit at 03/06/2012 12:43PM by Tastymango.