Субж. Экструдер охлаждается до 170С и ниже. ПИД регулятор настроен. Такое впечатление не хватает мощности нагревательному элементу. Что подскажете?
VDX
Re: Prusa i3 Hephestos. Кулер охлаждения платика охлаждает экструдер
September 28, 2015 01:32PM
... higher voltage and/or thermal isolation for the heater block ...


Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org]
Call for the project "garbage-free seas" - [reprap.org]
How can i rise the voltage on ramps 1.4 in Hephestos?
VDX
Re: Prusa i3 Hephestos. Кулер охлаждения платика охлаждает экструдер
September 30, 2015 04:19PM
... you can drive the heater with a (different) higher voltage - check, if you can change the heater support ... or use a DC-SSR (SolidStateRelay).

Some power sources can be adjusted by a trim-pot, so a 12V PS can be set to maybe 15V max ... but ensure, your electronics (and voltage regulators) can handle this ...


Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org]
Call for the project "garbage-free seas" - [reprap.org]
Sorry, only registered users may post in this forum.

Click here to login