Hello everyone. I am new to the hobby and have recently built a printer from BotMill's kit. I am able to print really high quality prints, but when skeinforge decides to take the long route with no extrusion, I get a delay when it starts back up and therefor no plastic or sloppy plastic. This is compounded greatly when printing in small areas that keep making the extruder go on and off.
Also, every ten minutes or so the plastic will come out molten and mess the layer up while dragging junk everywhere. This is sooo frustrating!
And to compliment these issues, the hot end will ooze the very moment the extruder stops, depleting its reserve. Please help if you can....I cannot stand to spend another two weeks honing this. thank you!
*extruding at 185c, yellow PLA, Gen 6 electronics, 210 float speed
-Will