I need base settings for wades extruder.
Posted by Mdbaughman2
|
I need base settings for wades extruder. June 02, 2010 04:19AM |
Registered: 14 years ago Posts: 54 |
I need the E_STEP_PER_MM value for Wades Extruder...? Thanx MB
Edit: oh and how many degrees per step is your motor.... mine is 1.8
oh and my nossle is 0.5mm
If your setup differs i can do the math... i just need a base setting... your nossel size and motor's degree spec...
Thanks a BUNCH MB
Edited 6 time(s). Last edit at 06/02/2010 07:20AM by Mdbaughman2.
Edit: oh and how many degrees per step is your motor.... mine is 1.8
oh and my nossle is 0.5mm
If your setup differs i can do the math... i just need a base setting... your nossel size and motor's degree spec...
Thanks a BUNCH MB
Edited 6 time(s). Last edit at 06/02/2010 07:20AM by Mdbaughman2.
|
Re: I need base settings for wades extruder. June 02, 2010 10:22AM |
Registered: 17 years ago Posts: 106 |
Check the very bottom of this page:
[objects.reprap.org]
There is an xls/ods document that you can punch your numbers into to get the steps/mm for the firmware.
----
[www.binaryconstruct.com]
[objects.reprap.org]
There is an xls/ods document that you can punch your numbers into to get the steps/mm for the firmware.
----
[www.binaryconstruct.com]
|
Re: I need base settings for wades extruder. June 02, 2010 01:53PM |
Registered: 14 years ago Posts: 54 |
|
Re: I need base settings for wades extruder. June 30, 2010 02:25AM |
Registered: 15 years ago Posts: 19 |
I also have a new Wade/Nophead extruder, and am a total noob.
Using the spreadsheet is great - but which steps_per_mm do I enter? steps_per_mm of feedstock? or filament?
And the "Ideal Head Feedrate" - This should be entered into the reprap host preferences?
Lastly - how fast should I be capable of extruding?
After experimenting for a while, I can extrude - but very slowly.
Thanks a bunch.
Using the spreadsheet is great - but which steps_per_mm do I enter? steps_per_mm of feedstock? or filament?
And the "Ideal Head Feedrate" - This should be entered into the reprap host preferences?
Lastly - how fast should I be capable of extruding?
After experimenting for a while, I can extrude - but very slowly.
Thanks a bunch.
|
Re: I need base settings for wades extruder. July 15, 2010 05:39PM |
Registered: 17 years ago Posts: 106 |
Check this out, its a great writeup on this calculation by The Brokentoaster Blog. Be sure to read the comments too.
Calculating E_STEPS_PER_MM for the Reprap Mendel
Edited 2 time(s). Last edit at 07/15/2010 05:41PM by jeffpark_.
----
[www.binaryconstruct.com]
Calculating E_STEPS_PER_MM for the Reprap Mendel
Edited 2 time(s). Last edit at 07/15/2010 05:41PM by jeffpark_.
----
[www.binaryconstruct.com]
Sorry, only registered users may post in this forum.