Blender help for Mini2440 enclosure

Hello :-)

I am working since a few days on improving the Mini2440 enclosure Thing:1795.


I am using Blender and now I have all done but I have problems on non-manifolds

Can someone help me, maybe guiding how should I do it in Blender? some technical advices on a way I should "clean" the non-manifolds? Or maybe even do that for me? (file is attached)

Thanks

Edited 1 time(s). Last edit at 02/21/2010 07:22AM by casainho.

---

---
New cutting edge RepRap electronics, ARM 32 bits @ 100MHz runs RepRap @ 725mm/s:

[www.3dprinting-r2c2.com]

I got it, by redesign again the meshes and be carefull with non manifolds :-)

---

---
New cutting edge RepRap electronics, ARM 32 bits @ 100MHz runs RepRap @ 725mm/s:

[www.3dprinting-r2c2.com]

Hi,
I suggestion you should go www.developmentboard.net have a look. They may could provide you the right enclosure for you mini2440 board.

Not sure why tomwu dredged up a 2-year-old thread, but it gives me an excuse to promote a friend's design:
[www.thingiverse.com]