3D printed shells for FPV quadcopter
Posted by KathyElecfreaks
|
3D printed shells for FPV quadcopter October 09, 2014 06:17AM |
Hi, here's the showcase of my 3D printed shells for UAV ( unmanned aerial vehicle ) quadcopter.
There's no screws or soldering needed at all. The motor mounts are also 3D printed. Check out:
Actually, it performs pretty well. See from Youtube.
I will update the 3D modeling very soon for downloading. You can print one because it's pretty low-cost.
There's no screws or soldering needed at all. The motor mounts are also 3D printed. Check out:
Actually, it performs pretty well. See from Youtube.
I will update the 3D modeling very soon for downloading. You can print one because it's pretty low-cost.
Sorry, only registered users may post in this forum.