Reprap 3D Printer`s kit-0.7mm Nozzle-with Extruder-Teflon tube and X carriage
Posted by 3dstuffmaker
|
Reprap 3D Printer`s kit-0.7mm Nozzle-with Extruder-Teflon tube and X carriage January 17, 2013 08:09PM |
0.7mm Nozzle with Extruder, Teflon tube and X center carriage
Why Should You Buy
Our 0.7mm nozzle is a high performance, very fast printing hot end and extruder assembly for use with 3dstuffmaker, RepRap and other 3D printers.
0.7mm Nozzle diameter for printing down to 0.2mm layers using 3mm filament.
If you are looking for high quality 3Dprints, do not hesitate to buy our extruder system.
For more information, click here
Why Should You Buy
Our 0.7mm nozzle is a high performance, very fast printing hot end and extruder assembly for use with 3dstuffmaker, RepRap and other 3D printers.
0.7mm Nozzle diameter for printing down to 0.2mm layers using 3mm filament.
If you are looking for high quality 3Dprints, do not hesitate to buy our extruder system.
For more information, click here
Sorry, only registered users may post in this forum.