Hi, I am selling a couple of my very well tuned modified RepRap Prusa Printers on ebay. They have Marlin firmware loaded on them. They can run either ABS or PLA, and can run either 3.0mm or 1.7mm filament (if you put in a 1.75mm hot end).
Currently, they are set up with 0.5mm nozzles and 3.0mm filament, but I can change it to a 0.35mm nozzle or for 1.75mm filament if you wish.
I am located in the US.
The Orange and Blue 3d Printer is here:
[
cgi.ebay.com]
The Red, White, & Green Printer is here:
[
cgi.ebay.com]
They are good to go, ready to ship, and come with 1 lb of Black ABS or PLA (your choice).
Thank You,
Beekeeper
Edited 1 time(s). Last edit at 12/06/2013 02:22PM by Beekeeper.
