I have printed off all the RP pieces for the Y-axis of the Mendel.
I have a heated bed setup so there is very little to no warping on them, except for the bar calmps which I printed before I had the heated bed, but they are still usable.I switched to PLA because I ran out of ABS.
They will need drilling out probably but they are all workable.
PLA
y-motor-bracket_1off
y-idler-bracket_1off
y-belt-clamp_2off
ABS Black
y-bearing-360-inner_2off
y-bearing-360-outer-_1off
y-bearing-180-inner_2off
y-bearing-180-outer-_1off
y-bar-clamp_10off
I was going to print a full set, but ran out of time/plastic, so when i get some more Ill probably offer the rest of the pieces to whoever buys these for $160 or so.
I can ship to the USA for $5, maybe canada(im not sure what kind of taxes and stuff it needs).
Pics here [
picasaweb.google.com]#
any questions?
If nobody here wants them they will probably go on ebay in a day or two.
Edited 2 time(s). Last edit at 02/07/2010 07:09PM by RustySpoon1121.
