Set of Mendel parts printed in PLA $200.00 (SOLD)

Here is the link to the ebay listing. You can save money by buying it direct. Thanks for looking.

Click here for listing


Here you can look at each part. Click here to see the pictures.

This is my third set. The first two I turned into fully operational mendels. This set was my first PLA.

There is a total of 97 parts. ***There is no extruder assembly included, you will need a Wade or Adrian extruder.*** They are listed on the forum for less than $20.00.

If I am missing anything just let me know and I will print it for you. No extra cost. These are the parts that I use to make my mendels. You can see my pictures at Assembled and parts

Edited 6 time(s). Last edit at 01/12/2011 12:29AM by Adventure.

You say it is a complete set, but my complete sets have 102 parts. You are missing an extruder and the belt splitter jig.

---

[www.hydraraptor.blogspot.com]

I leave the extruder up to the buyer. That is why I list everything I am selling with pictures. I will note that it does not include wades extruder. I use a modified MK5 on my mendel carrage assembly. We have come up with a slick design that fits inside the carrage. I will post pictures of what it looks like. I will look up the belt splitter. I have not needed it so far.

Edited 1 time(s). Last edit at 12/15/2010 07:52AM by Adventure.

Some of your parts are very poor quality, especially the x, y and z gears.
The y-bearing also looks strange.
You apparently have alternating z layers that match - very strange.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

I agree with Nophead.

People buying the parts are most likely to be new in the process and therefore not quite understand what they need.

They will not be able to tell from the pictures that you have not included extruder parts... unless they do some serious research and determine what each part does..

I think you are mis-advertising...

Quote
nophead
You are missing an extruder and the belt splitter jig.

Yes. Many RepRappers offering "full sets" allow the buyer to decide if he wants a Wade or Adrian extruder.
And of course the belt splitter is part of the Cartesian robot printed parts!

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Yes you are correct I did miss the belt splitter. I was using the following chart to check off each one.

[www.reprap.org]

They did not list the belt splitter so that is why I missed it.I will print it out and add it to my parts. I would think that most people would purchase a belt already cut to size like I have.

Edited 1 time(s). Last edit at 12/15/2010 11:48PM by Adventure.

I don't think T5 belt is readily available 5mm wide.

---

[www.hydraraptor.blogspot.com]

Quote
nophead
I don't think T5 belt is readily available 5mm wide.

No it's not.
Here in Germany 10mm and 16mm seem to be normal.
Of course 10mm is perfect when split you have two sets of Mendel belts.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Thanks for the info. I will be sure to include it.