Z-Axis Stabilizers Needed
Posted by evan_calgary
|
Z-Axis Stabilizers Needed April 21, 2013 11:17PM |
Looking for someone to print me a couple z-axis extruders. The kit that I purchased uses a simpler bar clamp system and I would prefer to continue using the instructions I have been which uses z-axis extruders. Would prefer black but not picky in the least. Am located up in Calgary, Alberta, Canada. Shoot me a pm please with cost and timeline...Its holding up my build 
Appreciate the help!
Evan.
Appreciate the help!
Evan.
Sorry, only registered users may post in this forum.