I had this same problem but to a smaller degree. When I ran the bed along the rails with the power off I could feel some unevenness in the travel. When I checked closely, the belt was occasionally climbing over the pulley tooth. I did think that my belts were tight enough, but when I tightened them more and was able to get a true low note when plucked the problem disappeared. I would recheck thaby tehenlai - Mendel90
nophead Wrote: ------------------------------------------------------- > The VAT on £499 at 20% is £99.80, where do you > get 205 from? I think the 205 is 20%by tehenlai - General
I’ve just finished building a Mendel 90 kit ( My 1st ever 3d Printer) and can highly recommend one from a new users standpoint. The entire process from ordering/payment/delivery/packing/ instructions was fantastic. The build process took me around 20 hours as I wanted to be sure I wasn’t doing anything stupid and I’m not great at soldering. After following the instructions to configure the firmwaby tehenlai - General