I bought prototype supply abs (blue) from amazon, it's on a small reel but it's working pretty nice so far. Good diameter, pretty uniform and it doesn't seem to have any moisture problems or anything. Toybuilderlabs.com has it tooby ForgetfulJones - General
igus self aligning bushings and hardened linear rails work great for me, some 3 in 1 oil every once in a while and they're like NO frictionby ForgetfulJones - General
makerfarm.com reprappro.com other than that, ebay and preassembled stuff, I'm sure there are tons more that's just to get the replies started...by ForgetfulJones - General
Lots of things wrong, is that object supposed to be canted like that?by ForgetfulJones - General
Yeah get a higher amp PSUby ForgetfulJones - General
Makerfarm has good glow pla but they're in the USby ForgetfulJones - General
Your'e going to disassemble and reassemble it a number of times for upgrades/repairs so yeah I would just wire them together temporarily and print new ones- or if you totally can't I can sell you some individual parts as a favor. Let me know if you need em, my email is dococtavius@yahoo.com and I woby ForgetfulJones - Reprappers
If it's abs turn off the fan. Mine was just cooling it too quick and now I get great prints with no warping. Keep the fan only for PLAby ForgetfulJones - General
I got an i2 kit from makerfarm.com, they include everything except the rods and glass and power supply. then you just upgrade it from there to get the quality you want. Works pretty well out of the box though, I would recommend a good fan duct and reel holder as your first printed upgrades.by ForgetfulJones - General
BTW that's not a z stepper that's eby ForgetfulJones - General
I had that too recently and it turned out to be a combination of firmware settings and too little/much speed. Try looking at your firmware settings and make sure your stepper voltage isn't too low or high, could be a lot of things.by ForgetfulJones - General
Awesome, thanks! I do some soldering at work so I should be okby ForgetfulJones - Reprappers
Nobody's done this? Just figured it'd be an easy answer. My heatbed output is constantly driving the relay closed, what would cause that?by ForgetfulJones - Reprappers
Hey guys, search found nothing on this, basically my printrboard rev D was melting the heatbed plug even at 60c so I hooked up a relay, it was working at first, but the plug was loose so I took it off, tightened the connectors and accidentally put it on backwards :\ Needless to say I blew the relay, the rectifier diode, and now that I replaced them I think I damaged the board, though everythingby ForgetfulJones - Reprappers
Hey new to the forums, just wanted to say I can't wait for issue 2. Been refreshing the main page for a week now Any ETA? I'm assuming the last day of Juneby ForgetfulJones - RepRap magazine