Show all posts by user
General discussions. For specific printers / electronics / fabrication methods / softwares, please see other sections.
Re: Marlin firmware print speed limit - 11 years ago
Thank You, sorry the ignorance, i am a newbie here. I am no a good G coder. There is anyway to set up this in the firmware, i can open the Firmware in the Arduino editor and change this parameter. Do you know where is this parameter?by Emmanuel2011 - General
Re: Marlin firmware print speed limit - 11 years ago
Thank you, that is a nice hack, but i will like to change the MAX speed parameter in the firmware...by Emmanuel2011 - General
I want to print faster but Marlin firmware has a speed Limit, HELP
- 11 years ago
HI, I have a Prusa i3 with a magma hot end. Now that my printer is reliable i wanted to increase the print speed. I always print at 70mm/s. I increased the print speed in Slic3r but it seems that my printer always print at the same speed no matter what i put in slicer. I was told that there is a speed limit in the Marlin firmware. Does anybody know where is this speed limit so i can modify this pby Emmanuel2011 - General
Re: Slic3r question - 11 years ago
i check that too. thank you but i still i have the issueby Emmanuel2011 - General
Re: Slic3r question - 11 years ago
i check that, but slic3er does this with every object. thank youby Emmanuel2011 - General
Slic3r question - 11 years ago
Hello, I am printing just solid disk with some holes, but slic3r adds an initial layer, like a support. I dont know what i did to slice3r because this is the first time i see this on my prints. Does any body knows how print wthout this unnecessary support. Please refer to the image Best Regards, Emmanuelby Emmanuel2011 - General
Re: PRUSA i3 / Hobbed bolt digging into filament - 12 years ago
you guys are genius, I got a 0.35 mm nozzle. I check the filament i got and it says 1.75 mm in the spool. They sent me the wrong filament ,because i am such a newbie i did not double check. Thank you, i just order new filament, i will keep you updated Emmanuelby Emmanuel2011 - General
PRUSA i3 / Hobbed bolt digging into filament - 12 years ago
Hello, I just builded a Prusa i3 from makerfarm. The Hobbed bolt is digging into filament always at the same spot (please refer to the picture) , I tried without results: 1. Adjust the idler bearing at different settings 2. lower the tempeture of the hot end 3. lower the speed in slic3r from 30 to 15 No matter what i do The hobbed bolt always digg the filament in exactly the same place, Cby Emmanuel2011 - General