Show all posts by user
General discussions. For specific printers / electronics / fabrication methods / softwares, please see other sections.
Re: Ramps 1.4 Problem - 5 years ago
+Hello All, boy am i in need of help im at the ready to give up stage, i converted my ANET A8 printer to use ramps 1.4 boards but have come up with a few problems first Im using win 10 with Repetier and Pronterface, with repetier the printer is dead it will connect but thats all with pronterface the XYZ move in the right direction but only one way extruder will heat to correct temp but the bedby RTTY177 - General
Re: Extruder Motor Wont Vary - 9 years ago
Am in trouble with my Prusa, Im using Repetier with ATMega boards extruding 1.75 mm, when I set up repetier and connect then go to the manual tab and after the extruder is up to temp if I try to extrude 10 mm of filiment the extruder just sits and nothing happens. Ive subed the motor and driver and all works as it should, I subspect my problem is in the software but Im at a loss as to where. Hoby RTTY177 - Ormerod
Re: Small print with repetier - 9 years ago
Thanks for the reply and yes it only happens with a few parts that Im trying to print, yes my printer setting are correct and Ive tried slic3r and cura as sliceing and get the same results.by RTTY177 - Printing
Small print with repetier - 9 years ago
Hi all Am having much trouble with my prints using repetier Version 1.5.4, tryed to print a part that should be 70 X 20 mm and end up with the print being 10 X 5 mm. Using a Prusa 1.5 printer and X and Y calibration seem ok in that if i move 10 mm it measures 10 mm, at this point Im at a loss as to the problem also if I use Repetier to scale a part up when I print it end up with the original parby RTTY177 - Printing
printer will not print - 9 years ago
Hello all as a newbe i seem to come to a brick wall, I have a DIY Prusa 1.4 with Arduino boards running Marlin software, my problem is I can connect with Repetier heat the extruder load a stl fil and slice same but i have no manual control of X, Y or Z and extruder if I try to print i get the preview of each layer but the printer is asleep for some reason. At this point Im at a loss to what mightby RTTY177 - Repetier