Show all posts by user
General discussions. For specific printers / electronics / fabrication methods / softwares, please see other sections.
Unknown wave? somthing on the output. - 10 years ago
Not like my expectaion on output forum here, My prusa i3 is sick now. As the each of the four corner, It seems fits well. but the mid diagonal parts, waves occurred. seem like getting better(2nd photo) the second layer is covering the waves. but finally(3th photo) errors originated from first layer waves makes waves everywhere! If the axes are not fitted right, it has to be strait to each ofby Cevitty - Reprappers
Re: Err: Continuous square only on Prusa i3 screen - 10 years ago
Thanks really! the firmware was the matter.by Cevitty - General
Err: Continuous square only on Prusa i3 screen - 10 years ago
I just built up my Prusa i3 kit but only shows that creepy screen is just on.(attached) I got a spare of ramps 1.4 board and a set of lcd sreen. I've tried to changed each of one but problem is same. Maybe the problem is arduino 2560 board but is there anything to control? heck I don't know. Please check this out.by Cevitty - General