Im building the Edgge 3D Printer 1.0(http://www.instructables.com/id/Edge-3D-Printer-an-affordable-open-source-3D-print/) and stumbled upon a problem. Im missing a 3D file , but got spare. The missing part is supposed to hold 2 bearings that press the belt against the pulley. But its missing in the 3D Parts list. Instead i got a part that i cat fit in anywhere I allready conntacted the "publishby JakobSachs - General
I dont know why or how, but it works. I was on vacation had no chance to build on it. So as i tried it today it suddenly worked, with the same firmware and the same hardware config as before. A huge thanks to you all, how helped.by JakobSachs - General
If i measure the Voltage that gets out of the assigned pins, im not getting 12 volts. Do i need to have the Hot end pluged in too or not? Also what do you mean with :" ... the ATMEGA2560 pin ..." , which pin it that? I googled it and dindt get a result.by JakobSachs - General
A little update, i got it to heat up by connnecting the heat end to heat 2. But it doesnt stop at maxtemp(275) and goes up to 300, where i disconnected the power. Any idea what could cause that?(I got my Motherboard set to EFF(Extruder,fan,fan) because i got no heat bed and only one extruder)by JakobSachs - General
I soldered the cabel ends so they dont shortcut eachother. They are both cliped into a screw terminal, which seems pretty solid. For my Hot-End i measured round aabout 60 Ohms. The cabels are wrapped with plastic fabric and are quite resistant to bending,by JakobSachs - General
OK i messured both resistance and got a value out of it. So what could it be ?by JakobSachs - General
Yes the thermistor works and gives me correct temperatures. Which resistance do you mean, thermistor or hot end ?by JakobSachs - General
Im building the Edge 3D v1.0(http://www.instructables.com/id/Edge-3D-Printer-an-affordable-open-source-3D-print/) and got all the parts gathered. I tried every single piece and at first i got my nozzle to heat up once. But now it wont. It doesnt show any errors, i connected it over USB and looked at the serial monitor. But here too, it doesnt give me any errors. I got a LCD for controlling the prby JakobSachs - General