i tried changing my probe offset to some other value. my mean mesh still shows ~-0.9.... This is just weirdby auggie246 - Firmware - Marlin
Hmm then why does my G1 Z0 shows that the nozzle is right above the bed. weird. I will play around with it for nowby auggie246 - Firmware - Marlin
Yes my Z_PROBE_OFFSET_FROM_EXTRUDER is at a number which when I do G1 Z0, my nozzle barely touches the bed. However after I do a G29 P1. my mean mesh is around -0.9 G29 T gives Bed Topography Report: (0,7) (7,7) (35,173) (192,173) -0.844 -0.805 -0.764 -0.815 -0.887 -0.964 -0.943 -0.98by auggie246 - Firmware - Marlin
How do I get the mean closer to 0? Do I shift my probe higher? Should my Z-probe offset be input before G29 P1 or should the offset be zero before G29P1.by auggie246 - Firmware - Marlin
-0.956070 is my value I should to make it zero?by auggie246 - Firmware - Marlin
Before I used Unified Bed Leveling (UBL), I was using bilinear leveling with BLTouch. everything was fine and calibrated. a 20mm calibration cube would come out ~20mm. But now that i implemented UBL, all my models have errors in Z height. a 7mm print became 8.5mm. a 20mm cube became 22mm, etc etc. Is this an issue with fade height? I am at a total loss here.by auggie246 - Firmware - Marlin
May i know what steps/mm are u using for trianglelab ones? If I use 837 like on the titan assembly wiki. my extruder push less than what it is suppose toby auggie246 - General
@DjDemonD, where did u get your clone titan btw? Trianglelab? I just got mine from them, the e3d v6 genuine fits a little snug but it's okay. the only complain I have is the black filament guide above the v6 is too short. It has a 2mm gap betwen the hobb and idler. I don't believe that is good for flexible filament.by auggie246 - General
Wow... looks like i am going to have some issues to fit my geunine e3d v6 on the clone titan then.by auggie246 - General
DjDemonD, are you using the clone titan from triangle lab with genuine e3d v6 via direct drive? or Bowden? I read on the aliexpress feedback page that the clone e3d titan does not fit the genuine e3d v6 via direct drive.by auggie246 - General