So, i am using PP in an underbed configuration, 3 20mm piezos. So many problems that i am designing a new housing to move this on the effector (i have a delta) Underbed has lots of issues: first the mass of the bed itself, that keeping the pressure on the piezos forces you to decrease the sensibility, then vibration from the motors that on the bed is a lot more perceivable then the heated bed haby diego.trinciarelli - General
So, for anyone interested in how to configure on the FLSun Kossel Delta and Marlin with the PrecisionPiezo V2 universal board, here you go: I used an underbed mount, i like to not have more wires going to the effector #Printed Parts: i added a small rubber adhesive layer to insulate from heat and keep the bed from moving. This rubber is pretty hard and does not flez. #Wiring: Just wire the Zby diego.trinciarelli - General
Labels on the MKS are non-present. Using a multimeter actually saved me from hours of blind testsby diego.trinciarelli - General
Hello DjDemon, so your test actually works (as the board), by just unplugging the green connection i get the proper behavior. I found out it was bad wiring, one diagram i had of the board indicated the wrong orientation of the pins, so i was inverting +5v and TRG. Using the multimeter i was able to figure out the right polarity. Now i will try to configure Marlin and see what happensby diego.trinciarelli - General
Hello everyone, i am writing here since i cannot really get this sorted oout: I bought the Precision Piezo kit, and i am trying to install with 3 point underbed. Already printed all holders and connected to the MKS but i cannot make the piezo work as per instructions: Setup: FLSun Delta with MKS Board 1.0 running Marlin. Piezoboard V2 universal. 3 piezo disks connected to the piezo board and pby diego.trinciarelli - General