Show all posts by user
General discussions. For specific printers / electronics / fabrication methods / softwares, please see other sections.
Re: Marlin new firmware 1.1.9 - 6 years ago
Open with arduino software and find LCD controller then delete"//" REPRAP FULL GRAPHICS CONTROLLER and check.by Alex85Hill - General
Re: Marlin 1.1.9 and Ramps 1.6 - 6 years ago
I have problem with ramps 1.6 and MEGA 2560 all stepper motors not move. I though that marlin for Ramps1.4 fit to Ramps 1.6. But All times figure out and not works. I contaced to BIQU RAMPS 1.6 and they gave me marlin for Ramps 1.6. And I uploaded it to Mega 2560. There a lot of errors. I think that they did not check for any 3D printer. They check their own 3d printer. What parts you have and fby Alex85Hill - Firmware - Marlin
Build Own 3D printer - 6 years ago
Hi. Everybody. Did you build 3D printer with hotbed CR10 400mm with 12V to Board Printrbot F5? Should I add mofset power supply to connect Board F5, PSU 480W(PC) and heatbed CR-10? Or what I need? Thanks.by Alex85Hill - General