Yes buddy I tried those settings as well and even tweak them slightly higher and lower as well. The problem didn't fixed. Even changing the value of baudrate didn't help either. Although there are few values on which it didn't work at all. But I saw people built CNC with Arduino and TB6560. If that worked well then why with the ramps board it's didn't go that well. Even I tried those baud rate anby ambros - General
Hey buddy thanks for the reply, but the solution is way too costly, I saw people on the internet running the motors with mega 2560 and 6560 or 6600. If you knew any setting work best with those please tell. I am not experienced in this work and I didn't even knew about that board which you tell, if I knew about that I will definitely prefer that but now I already spent too much onto the parts whiby ambros - General
Hi guys, I am working on 3d printer in which I am using NEMA 23 to drive my all axis. For the drive, I am using ball screw having 7 threads per inch. The motor modal is 23HS6403. The reason for choosing those motors is because this is going to be a 3 in 1 CNC build. To run and control 3d printers electronics I have to use ramps because without ramp it would be very difficult to remap everything.by ambros - General
Hi guys, I am working on a 3d printer and the motor I am using is NEMA 23 which are recovered from my old machine. Every motor works fine, but the extruder motor is NEMA 17 having the same current value. But when I give extrude command it only vibrates, but if I plug NEMA 23 in same port there will be no issue. If I plug that NEMA 17 motor in other pins like x,y,z it didn't move either. The motorby ambros - General