For those looking for an answer, I noticed I was getting the following message "Low memory available, stability problems may occur" when compiling the sketch. I tried to comment everything related with LINEAR ADVANCE on "Configuration_adv.h", just because I'm not using this function. It freed some memory and now I don't get this error any more and the nozzle is moving smoothly as it should. So apby paulorfo - Firmware - Marlin
Hi, I have a Tevo Tarantula, was using EasyConfig 1.0.X, so far so good. Flashed the 2.0.X using Arduino 1.8.10. The printer vibrates while printing curves. Tried the official Marlin BugFix 2.0.X version after optimize it to work on my printer. Same thing happens, but it also slows down printing straight lines and it ends up with some "columns". I used the same Gcode for all my tests. I played wby paulorfo - Firmware - Marlin
Thanks, I'll try. I've been reading a lot to understand the schematics and installation. I'm totally dumb when it comes to eletronics.... I'm afraid to burn something. That's why I'm asking for clear instructions. In any case I appreciate all the effort.by paulorfo - General
Can you post pictures of the wiring scheme and the resistor? I have the NPN sensor and I'm trying to figure it out how to wire it and where plug each cable. I know I need to conect a resistor as well.by paulorfo - General