i never knew a 'cd punch' existed lolby simonemery555 - General
just quickly punched through a failed previous disk as per pic to show drilled vs hole punch i use "Rapesco Sole Single Hole Punch Plier - 23 Sheet 6mm Hole" off amazon - its £4.12 on prime..by simonemery555 - General
Ive been tinkering with the piezos for a while now. i have the universal set 2.85 as i mentioned above, but i think i should of gone for the orion and redesigned my hotend. i just cant seem to get a good balance between a solid hotend, and accurate sensitivity. Loosening it up its perfect on levelling but the prints are not clean and accurate as there is a wobble on the hotend when there is a diby simonemery555 - General
I wholeheartedly agree, i work for a software dev company and we also have companies trying to rip what we do.by simonemery555 - General
Thanks for the advice! I’ll get it ordered. Going with a legit one for the support - there are so many clones. Must suck for the creators.by simonemery555 - General
Ah ok thanks! This cheapie lerdge board is simply a stop gap as my Geeetech one failed. Nearly pulled the trigger on a duet WiFi, but stopped when I heard there is a new one coming out.by simonemery555 - General
yay! thank you - thats solved it perfectly!by simonemery555 - General
thanks Idris, Its a heavily modified Geetech A10 - the controller board is a lerdge x 32bit. Been happily using 3dtouch and bltouch probes but fancied the piezo. Board details: autoleveling details: i didnt realise there was 2 sets of pins - its connected to A (i followed the pictures to connect)by simonemery555 - General
I have just installed my 2.85 board and piezo, but having a few issues. I've set it up to be what i believe is optimal sensitivity as in the manual. If i knock/tap the hotend, i can get it to trigger (change from red to blue), but the printer only responds to this sometimes. On further investigation, if i tap the nozzle, i can get it to trigger on the leds, but not the printer, but equally, iby simonemery555 - General