I actually found documentation at the Marlin site, but not specific to the Anet A8. Also, can someone tell me when I am compiling, I get two errors that show while compiling, but finishes compiling with a done compiling finish. The upload also goes through with no problems. The following is the two strings of text I get. While compiling they show as yellow or amber text, not red. Error while dby 3D Printer Dude - General
QuoteRoberts_Clif You might give this a look. Marlin/example_configurations/Anet/A8/ Yea, I have already done the config h, and config.adv from the Marlin parckage for the Anet A8. And the ones from GitHubby 3D Printer Dude - General
Thank you, but no that doesn't delve into Marlin upgrading, just the basics. Need to know all the things that you have to do to the Anet A8 once you have flashed Marlin onto your board, like axis adjusting for home position etc. I have checked YouTube, but most videos are on the process of how to download Arduino & Marlin, and how to flash your board and nothing on the things that you have tby 3D Printer Dude - General
And step by step instructions can be found where?by 3D Printer Dude - General
I have an Anet A8 and just flashed my system with Marlin 1.1.9 I booted up system and tried getting used to the difference in the LCD, which mine is the 2004. Upon moving each axis, I found that in one direction I could take it to the limit, but the other way, it would only go so far. Z Axis: would go up as far as I wanted, but down, would only go down about 4" above hotbed and stop. Not even getby 3D Printer Dude - General