Ok, I move from skr to an arduino, with teacup. I wire only the steppers, and its look great. all works fine so now i have confirmation that isn't my drivers and motors I only need to know if it's a firmware bed config or my boardby ScornInPC - General
Hello all! I'm facing a problem that's i not found nothing on forum When I run 10mm, its all ok, from 3 axies. But when I send run more than 20mm, on +/- 16mm the borard reboot (this occur only on X and Y) That's not psu, because i have changed for others and now i'm using 12v 350w psu Z axis are the only thats work. I can move 100mm with no problem. So, i decided plug X on Z header board, anby ScornInPC - General