Okay, just be careful with the commands, I chose the tool "1" in the M104 command, but it should have been "0", from this the printer cursed at the wrong tool (actually not set).by FirstBarrel - Printing
... is eventually another tool (T1 or higher) selected in the G-code? No, I only have one extruder, I named it "Extruder 1". In the Cura settings, I did not find where you can select the number of the tool, I did not insert it in the starting gcode. M92 X160 Y160 M140 S{material_bed_temperature} ; start preheating the bed M104 S{material_print_temperature} T1 ; start preheating hotend G28 ;Homeby FirstBarrel - Printing
Okay, my printer successfully uploads the model via wifi, I can extrude the filament by selecting the current tool, but when I load the model for printing, it gives me the wrong tool number. FIRST time today he typed normally, but now he again inserts this stupid mistake for me. The order of my actions: I select the tool in the web control, make sure I can select extrude-retract filament, afterby FirstBarrel - Printing
I use a thermometer "rgk ct-11" for measurements, it is a contact, type k thermocouple, I attach it to the block with a metal clothespin.by FirstBarrel - General
Hello, I have been struggling with the problem that my ntc 100k 3950 sensor shows the wrong temperature for three days now. I have a thermometer for calibration, and so, at a temperature of 25 degrees, the difference in the readings of the printer-thermometer is about 0.4 degrees, at 70-100 degrees - 10, at 200 and above degrees - already 20-40 degrees. Reprap 3.4 firmware, rrf e3 board, my settby FirstBarrel - General
I measured the voltage at the output of the pins of the limit switches, on the z axis there are some millivolts, when x and y are about 3.3 volts.by FirstBarrel - Firmware - mainstream and related support
Yes, I understood that, but the question is about the microswitch.by FirstBarrel - Firmware - mainstream and related support
Hi I'm trying to upgrade my ender6 with my coreXY kinematic, the z-stop switch is not working for me. I've rung it with a multimeter - it's set to normally closed and rings when it's not closed, and doesn't ring when it's closed, as it should, so the switch circuit isn't the problem. I have already configured the firmware via , where I set the z-switch, and disabled the bl-touch. M119 gives theby FirstBarrel - Firmware - mainstream and related support