Thanks for the reply, just getting back to this. It just doesn't work swapping motor wires or inverting the wire. I think my problem is the location of the end stops. The x is back left hand side and the y is at the back too. There should be a way to this. I could move the end stop but the way the machine is configured back left is the best spot for the x endstop. Any ideas?by Holy1 - General
QuotePaul Wanamaker The main thing is to make sure your printer is moving in the right direction. I've drawn up this diagram: So if you command X+ the nozzle should move to the right. If you command Y+ the printbed should move toward you. As noted above, you can reverse the stepper wires for the motor going in the wrong direction (with power off) or change the Invert setting in firmware. Seby Holy1 - General
Quotekokoi Hello, I had the same issue with my Prusa i3 maxi. Mirrored along X axis. The aim is to use the X endstop not as MIN endstop but as MAX endstop What I did: Check the config by sending M119 in pronterface. SENDING:M119 Reporting endstop status x_min: open x_max: TRIGGERED y_min: open y_max: TRIGGERED z_min: open z_max: TRIGGERED Disconnect and shutdown. Connect the X endstop on theby Holy1 - General