Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
My board is a Melzi Ardentissimo with an SD card slot on it. The manual instructions (in Chinglish) says I can load a gcode file in the root directory and run it from there. I am yet to try it out.
Cheers!
by
ozzieengineer
-
Australia, Brisbane RepRap User Group
Hi dansxmods,
Good news and bad news. Good news is that I got it all working and it prints great! I found that dust had accumulated in the extractor. Once I had totally cleaned it, it was extruding really well. I also found that my bed wasn't completely flat. The clips at each corner of the glass plate were pulling down the glass.
Now the bad news - I had to use Windows to get the software sta
by
ozzieengineer
-
Australia, Brisbane RepRap User Group
YES! I have a RepRap (recently purchased) which I am trying to get to run with Ubuntu 14.04. This is not being very successful so far (still haven't printed anything as yet). I am working through on-line manuals and documentation and forum comments to get a comms issue resolved. Would be interested in any help to resolve.
by
ozzieengineer
-
Australia, Brisbane RepRap User Group