Show all posts by user
(RepRap en Français)
Page 1 of 1 Pages: 1
Results 1 — 8 of 8
Hi,
my CoreXY DIY printer is equipped with a BLTouch. This one works well and is well set.
After homing (whatever homing is done : 1 touch or Bilinear) the bed moves down 10mm then 20 mm before the hotend moves to the beginning of the print and starts to print.
Due to the poor quality of my lead screws, I often get some inaccuracy when the bed moves back to the "0" position.
So I would like to su
by
Thierry72
-
Firmware - Marlin
Hi,
Ihave upgraded the version of MArlin to 2.03.9 and I can't read my SD card from the LCD.
Below are the different options I have selected :
#define SDSUPPORT
#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
#define SDCARD_CONNECTION LCD
If I swich on my printer without a card in the LCD slot, the lign "No Media" shows up and if I insert a SDcard, it is not detected, so I have to switch o
by
Thierry72
-
Firmware - Marlin
Bonjour à tous.
Savez-vous comment afficher avec Marlin 2.0 le pourcentage de l'impression en cours sur l'écran ?
Il me semble bien que c'est possible, mais comment ?
Cordialement
Thierry
by
Thierry72
-
RepRap Groupe d'Utilisateurs Francophone
Bonsoir à tous,
je n'arrive pas à paramétrer Marlin pour mon 3DTouch (lors d'un AutoHome l'axe Z ne descend pas).
Je cherche une configuration Marlin complète que je pourrai comparer avec la mienne (je pense qu'il faut plus que le config.h)
Cordialement
Thierry
by
Thierry72
-
RepRap Groupe d'Utilisateurs Francophone
Bonsoir à tous.
J'ai installé un 3DTouch, configuré et téléversé Marlin dans l'Arduino+Ramps de mon Anet A6.
Que ce soit dans Pronterface ou sur le panneau de commande de mon imprimante, le 3DTouch s'allume, s'autoteste, de déploie et se replie.
Mais quand je veux le calibrer, je n'y arrive pas.
Je commence par faire un Auto Home dans Pronterface.
Qui me renvoie ceci :
onnecting...
start
Prin
by
Thierry72
-
RepRap Groupe d'Utilisateurs Francophone