Show all posts by user
(RepRap en Français)
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
After a week of hard trying, configuration and other crying, I finally resolder all pins on Re-arm and Ramps plus Re-arm CPU with a hot-gun and then...perfect !
Thanks a lot for your help !
by
necris38
-
Firmware - Marlin
Yes I've seen this too but...no way :-(
I have tested it on my A8 board: is fully functionnal...
I'm so upset for now :-(
by
necris38
-
Firmware - Marlin
I try several value but the issue is the same.
I don't think it's electrical interference issue cause only the board+screen are powered on my desk.
Some says It's a SPI problem...
by
necris38
-
Firmware - Marlin
Hi !
I try to put Marlin 2.0 on my Re-arm+RAMPS1.6 board with a RepRapDiscount Smart Controller.
I attached this as described here:
And I get that ...
All pins were checked twice, I don't know how to fix this...
Any Idea ?
by
necris38
-
Firmware - Marlin
Bonjour à tous,
J'ai une A8 sous Marlin 1.1.8 avec un chassis rigide Tatara qui me donne des résultats satisfaisants depuis 1 an mais je souhaiterais l'améliorer.
Je souhaite garder les moteurs et changer uniquement la carte contrôleur et les drivers.
J'étais parti sur une Ramps 1.4 ou MKS GEN-L mais je me pose la question du 32 bits (Re-ARM ou MKS SBASE).
Est-ce que la puissance de calcul appor
by
necris38
-
RepRap Groupe d'Utilisateurs Francophone